Kiln Master Wall Mount Control

Regular Price
$1,495.00
Sale Price
$1,495.00
Regular Price
Sold Out
Unit Price
translation missing: en.general.accessibility.unit_price_separator 
Only 1 left

Ask us a question

The KM1 Wall Mount Controller can upgrade just about any Kiln Sitter controlled kiln under 50 Amps with a NEMA 6-50 plug to perform just like an automatic kiln. Just plug your kiln into the back of the controller, plug the controller into the wall outlet and install the thermocouple.

When you are ready to fire, turn all of your switches to high, place a cone in the Kiln Sitter that is 1 cone higher than your target temperature, set your timer and press in the plunger. The KM1 will then cycle the power to the kiln on and off to run your desired program. It has all of the advantages of a normal automatic kiln with the added benefit of a Kiln Sitter backup.

Unfortunately Zone Control, KilnLink, and Current Sensing are not available with this setup.

Works with both 240 and 208 volt single phase kilns.