Melt Gloop glazes are a stoneware glaze designed for application in dots or creating a dripping effect down your ceramic piece using a syringe or squeeze bottle.

General Use

Before application: Stir thoroughly using a stick, palette knife, or the end of your brush, as it will be very thick in the jar. For better adhesion, lightly dampen the bisque surface with a sponge before application. Effects are achieved by applying the glaze with a syringe or squeeze bottle. A ceramic glaze syringe with a cap or the Mayco AC220 Detailer Tips and Bottle is recommended for precision. When cutting the Detailer Tip, be careful not to cut too far down, as this can affect the control and flow of the glaze during application.

Basic Application: Apply dots in varying thickness and patterns to greenware or soft-fired, cone 04 stoneware bisque (1940°F/1060°C). For more movement and a dripping effect, apply larger dots on a vertical surface. The glaze can flow over textured areas. Continuously shake your applicator tool during use to eliminate air bubbles that can disrupt the flow of glaze and cause uneven texture or splatter. Allow the glaze to dry. It is recommended to fire your piece as soon as possible to prevent issues with glaze adhesion. Fire to preferred temperature; cone 5-10 (2167°F-2345°F/ 1186°C-1285°C). Sample tile was fired to cone 6 oxidation (1222°C/2232°F). Testing is recommended. Results may vary.

Storage: Due to the thickness of Melt Gloop, it’s recommended to level out the glaze by gently tapping the product jar onto a table surface after application. This helps alleviate any peaks in the glaze that could lead to drying issues.